I'm not sure if this is an error or just a warning but I got the following message when I loaded my annular eclipse script.
"The 100% ratio of non incremental over regular exposures is too high. It should be 10% at most to optimize the number of exposures taken in a certain timeframe"
I'm not even sure what this means. My script takes a few shots pre-C1 and then goes from 1-96% and then runs through annularity at 5 sec intervals (starting at 30 sec before C2 to 30 sec after C3) with 1 sec intervals around C2 & C3 (just in case there are some beads to be seen). After C3 it runs from 96 to 1% again.
Any suggestions?
Clear Skies
Charlie